LFT-G acrylonitrile butadiène styrène ABS matières premières remplissant le plastique modifié en fibre de verre longue 12mm

What is ABS?

ABS (ABS is the acronym of Acrylonitrile Butadiene Styrene copolymer), also known as ABS resin, is a kind of thermoplastic polymer structural material with high strength, good toughness and easy to be machinated. ABS engineering plastic appearance is opaque ivory grain, its products can be colorful, and has high gloss.

Why filling Long glass fiber?

LFT & LFRT, Long fiber reinforced thermoplastic engineering plastics, compared to conventional short fiber reinforced thermoplastis, typically have a fiber length of less than 1 to 2 mm in conventional short fiber reinforced thermoplastics, while the LFT process the thermoplastic engineering plastics produced have been able to maintain fiber lengths above 5 to 25 mm. The long fiber is impregnated with a specail resin system to obtain a long strip which is suffciently wetted by the resin, and then cut into a desired length as required. According to the final different applications, the finished product can be used foe injection molding, extrusion and molding, Etc., directly used to replace steel and thermoset products.

Advantages of ABS-LGF

1 glass fiber reinforced, glass fiber is a high temperature resistant material, therefore, the heat resistant temperature of reinforced plastic is much higher than before without glass fiber, especially nylon plastics.

2. After glass fiber reinforcement, due to the addition of glass fiber, the mutual movement between polymer chains of plastic is limited, therefore, the shrinkage rate of reinforced plastics decreases a lot, and the rigidity is greatly improved.

3. After glass fiber reinforcement, reinforced plastics will not stress crack, at the same time, the anti-impact performance of plastics is improved a lot.

4. Après le renforcement de la fibre de verre, la fibre de verre est un matériau à haute résistance, qui améliore également considérablement la résistance du plastique, telle que: résistance à la traction, résistance à la compression, résistance à la flexion, améliore beaucoup.

5. fibre de verre renforcée après, en raison de l'ajout de fibre de verre et d'autres additifs, les performances de combustion des plastiques renforcés ont beaucoup diminué, la plupart des matériaux ne peuvent pas s'enflammer, est une sorte de matériau ignifuge.

Fiche technique pour référence

Application de l'ABS-LGF

Principalement utilisé dans les pièces porteuses et les pièces structurelles

Des détails que vous vous demandez peut-être

Notre entreprise

Nos équipes & nos clients

Nous vous proposerons :

1. Paramètres techniques des matériaux LFT & LFRT et conception de pointe.

2. Conception et recommandations de l'avant du moule.

3. Fournir un support technique tel que le moulage par injection et le moulage par extrusion.